Loving Joy Cock Rings with Removable Bullet Vibrator

Thank you for purchasing the Loving Joy Cock Ring with Removable Bullet Vibrator. Please follow these instructions to ensure the safe, optimal, and effective use of your product.

This instruction guide applies universally to all three silicone ring designs in the range. All models feature a velvety-soft, ultra-stretchy silicone ring attachment coupled with a removable, high-intensity silver bullet vibrator.

Contents

• 1 x Loving Joy Elastic Silicone Cock Ring (Double Ring, Rabbit Ears, or Flared Crest style)

• 1 x Removable Single-Speed Silver Bullet Vibrator

• 3 x LR44 Button Cell Batteries (Pre-installed inside the bullet)

• 1 x User Manual

Battery Activation Instructions (First-Time Use)

Your device comes equipped with 3 x LR44 button cell batteries pre-installed. Before your very first session, you must remove the transit insulator to activate the power.

1. Extract the Bullet: Gently stretch the elastic silicone housing loop and slide the silver bullet vibrator out of the ring attachment.

2. Open the Chamber: Ensure your hands and the toy are completely dry. Firmly hold the bullet body and unscrew the end cap (the end with the power button) anti-clockwise.

3. Remove the Insulator Blocker: Locate and remove the small white protective paper disc or plastic cap inside the chamber. This blocker is strictly in place to stop the batteries from connecting and draining during transit.

4. Check Battery Alignment: If the 3 x LR44 button cell batteries slip out while removing the blocker, simply stack them back inside the chamber sequentially, ensuring they are all facing the correct direction as per the internal markings.

5. Seal and Reassemble: Screw the end cap back on clockwise until it is tight and flush. Slide the activated silver bullet back into its elastic silicone holder loop on the ring.

Operating Instructions

Engineered to help maintain a harder erection, enhance male stamina, and deliver intense, hands-free clitoral or scrotal stimulation directly to your partner during thrusting.

1. Power On/Off: Press and hold the button on the flat end of the silver bullet for 3 to 5 seconds to initiate the vibration. To turn the device off, press and hold the button down again for 3 to 5 seconds until the motor stops completely.

2. Vibration Profile: This premium, high-frequency bullet operates on a single, continuous, deep rumbling speed designed to maximize external stimulation without the need to cycle through settings mid-play.

3. Fitting the Ring: Apply a generous layer of water-based lubricant to your penis and the inner rim of the silicone ring. While flaccid or semi-erect, gently stretch the elastic ring and slide it down to the very base of your shaft (or shaft and testicles if using the Double Ring style), ensuring the vibrating bullet sits on top facing forward to make direct contact with your partner’s clitoris or vulva.

4. Customisation: The bullet vibrator is completely removable. It can be taken out at any time to be used independently as a handheld clitoral stimulator, or swapped out entirely and replaced with any other standard-sized bullet vibrator from your collection.

Cleaning, Maintenance, and Waterproofing

1. Isolate Before Cleaning: Always slide the silver electronic bullet completely out of the elastic silicone ring attachment before introducing water.

2. Washing the Silicone Ring: Wash the silicone cock ring thoroughly under warm running water using a mild, unperfumed anti-bacterial soap or a specialised sex toy cleaner.

3. Cleaning the Bullet: Wipe down the rigid ABS plastic silver bullet carefully with a damp cloth or a targeted antibacterial toy spray.

   • > Waterproofing Note: While the elastic silicone ring sleeve is 100% waterproof, the removable silver electronic bullet is not submersible. Never submerge the bullet or hold it under heavy running water, as moisture crossing the screw cap threads will permanently corrode the button cell contacts.

4. Drying & Storage: Thoroughly dry all components with a lint-free towel. Once 100% dry, reassemble the bullet into the ring. Store in a cool, dry place inside a cloth pouch or its original packaging.

Safety Precautions & Battery Care

• ONLY use water-based lubricant. Because the ring attachments are crafted from premium silicone, using silicone-based lubricants, massage oils, or Vaseline will cause an irreversible chemical reaction that softens, breaks down, and permanently melts the material.

• The 20-30 Minute Constriction Limit: To ensure safe usage and maintain healthy blood flow, never wear a cock ring for longer than 20 to 30 minutes per session. Remove immediately if you experience any numbness, sharp discomfort, coldness, or skin discolouration.

• Battery Maintenance: If you do not intend to use the bullet for several weeks, open the cap and remove the button cell batteries. Batteries left inside long-term can leak or corrode, permanently ruining the internal contact springs.

• Keep out of reach of children and household pets.

Customer Support

If you have any questions, troubleshooting issues, or concerns regarding your Loving Joy Cock Ring with Removable Bullet Vibrator, please reach out directly to our dedicated customer service team. We are here to support you as best as possible to ensure you get the most out of your experience!

Enjoy your customisable, targeted experience with the Loving Joy Cock Ring with Removable Bullet Vibrator!

Important Safety Warnings for Your Loving Joy Cock Rings with Removable Bullet Vibrator

To ensure a safe, comfortable, and stamina-enhancing experience with your Loving Joy Cock Rings with Removable Bullet Vibrator, please read and strictly adhere to the following safety guidelines. Because this item combines elastic silicone constriction rings with a removable, rigid ABS plastic button-cell bullet vibrator, strict attention to wear times and battery handling is vital.

1. Wear Time Limits and Circulation (The 30-Minute Rule)

• Strict Time Limit: Never wear the cock ring for longer than 30 minutes at a time. By design, constriction rings restrict blood flow to increase firmness and stamina. Leaving the product on for longer than 30 minutes starves the delicate penile and testicular tissue of fresh oxygenated blood, which can cause permanent nerve damage, severe tissue bruising, erectile dysfunction, or priapism (a dangerous, prolonged erection requiring emergency medical care).

• Remove Immediately If: If you notice any extreme bruising, coldness to the touch, deep purple or blue discolouration, sudden throbbing pain, or a complete loss of sensation, remove the ring immediately.

• Do Not Sleep: Never fall asleep while wearing this product. If you lose consciousness while blood flow is restricted, the results can be catastrophic.

2. Sizing, Placement, and Genital Safety

• Pinch and Friction Hazard: Genital skin is incredibly thin and easily trapped. Use a generous amount of water-based lubricant during application to avoid pulling pubic hairs or painfully pinching skin folds.

• Correct Placement: This ring set is designed to be worn around the base of the erect penis, or around both the penis and testicles to anchor the vibrating bullet securely against the body. Never place a ring solely around the scrotum or testicles, as this can trap them and cause severe injury.

• Erection Changes: Genital tissue naturally swells during use. A ring that feels comfortably snug at first can quickly become uncomfortably tight as blood pools. Regularly check your comfort level.

3. Battery Management & First-Use Activation

• Transit Blocker Removal: Slide the silver bullet vibrator out of its elastic silicone holder and unscrew the cap. Remove the small white protective cap or paper disc located inside. This blocker must be removed to allow the electrical circuit to connect, as its only purpose is to prevent the batteries from draining during transit.

• Button Cell Discipline: The device requires 3 x LR44 button cell batteries (included). If they slide out, stack them back inside ensuring they all face the correct direction. Never mix old and new batteries, or mix different brands. Button cell batteries can leak toxic chemicals if left flat inside a device; remove them entirely if the toy will be left unused for more than a few weeks.

4. Electrical & Waterproofing Safety (The Two-Part System)

• The Removable Bullet: While the silicone ring attachment is completely waterproof, the silver ABS plastic bullet vibrator is strictly non-submersible.

• Avoid Water Submersion: Never submerge the bullet vibrator under water or use it in a bath. If water leaks past the screw threads of the bullet cap, it will instantly short-circuit the single-speed motor, ruin the electronics, or cause a mild electric shock. Ensure the bullet and your hands are completely dry before unscrewing the cap.

5. Lubricant Compatibility (Crucial for Silicone Rings)

• Water-Based Only: You must strictly use a high-quality water-based lubricant to aid application, comfort, and removal.

• Never Use Silicone Lubes: Do not use silicone-based lubricants under any circumstances. Because the flexible ring harness is made from 100% silicone, a silicone-based lube will chemically react with it, permanently melting the material, making it sticky, degraded, and completely unusable.

• Avoid Oils: Avoid oil-based products (such as Vaseline, baby oil, or body lotions) as they will quickly degrade the silicone structural integrity and break down latex condoms.

6. Cleaning, Maintenance, and Storage

• Always Separate the Parts: Before cleaning, you must completely slide the silver ABS plastic bullet vibrator out of its elastic silicone holder.

• Washing:

  • Silicone Rings: Wash thoroughly with warm water and a mild, unscented antibacterial soap or a purpose-made toy cleaner. Because it is 100% silicone, you can sterilise the ring attachment by boiling it in a clean pot of water for 3–5 minutes (ensure the bullet is removed first). Allow it to cool completely.

  • ABS Bullet: Wipe the silver casing and power button down carefully with a damp antibacterial cloth; do not submerge it under water.

• Keep Separated in Storage (Critical): Never store the silicone ring harness touching other silicone toys. Left in contact, different silicone items will chemically react and permanently melt into each other. Store your dried rings and bullet inside their original packaging or wrapped inside a clean, separate, breathable cloth pouch. Keep it in a cool, dry place.

7. Emergency Removal Protocol

• Difficulty Removing: If the ring becomes trapped due to unexpected swelling or an intense erection, do not panic. Apply ice packs or take a cold shower to naturally reduce the erection and shrink the tissue. Use a generous amount of liquid soap, shower gel, or water-based lubricant to carefully slide the ring off.

• Seek Emergency Medical Help: If you cannot remove the ring after trying cold water and lubrication, or if your genitals become intensely painful and discoloured, go immediately to your nearest hospital A&E department.

8. Regular Inspection

• Check for Structural Tears: Before each use, gently stretch the silicone ring loops and inspect them for any hairline cracks, nicks, or small tears. Because this item is under high physical tension when worn, a small nick can cause the silicone to snap violently during use, resulting in painful snapped-skin injuries. Discard the ring attachment immediately if any damage is found. Turn the bullet on to verify the single-speed continuous vibration functions correctly before positioning it.