Rev Automatic Penis Pump

Important Safety Warnings for Your Rev Automatic Penis Pump

To ensure a safe, comfortable, and effective training session with your Rev Automatic Penis Pump, please read and strictly adhere to the following safety guidelines. This motorized vacuum device features a 3-speed automatic suction system, an instant pressure-release valve, and a hybrid construction of a rigid ABS cylinder paired with flexible silicone and TPE comfort sleeves. Because vacuum pressure alters blood circulation, strict compliance with usage times and material care is vital.

1. Pumping Time Limits & Pressure Management (The 15-Minute Rule)

• Strict Total Session Limit: Never pump for longer than 15 minutes per session. Exceeding this time frame starves penile tissue of oxygenated blood, which can lead to severe bruising, internal bleeding, numbness, or permanent erectile injury.

• Gradual Progression: This device features 3 automatic suction speeds. Always start on the lowest speed to allow your tissue to adapt. Press and hold the power button to turn the pump on, and give it a short press to increase the speed.

• Listen to Your Body: Vacuum pumping should create a sensation of fullness and stretching, never sharp pain or intense throbbing. If you experience pain, coldness at the tip, or immediate dark purple discolouration, stop pumping immediately.

• Avoid Over-Pumping: Excessive suction can cause fluid retention under the skin (edema), painful water blisters, or ruptured blood vessels (petechiae). More pressure does not mean faster results.

2. Instant Pressure Release Mechanism (Crucial Safety Feature)

• Locate the Button First: Before you even place the cylinder over your body, familiarize yourself with the manual safety valve. To release vacuum pressure instantly, press and hold the black button located directly under the power button.

• Emergency Protocol: If the automatic motor malfunctions, pulls too aggressively, or causes sudden physical pain, do not try to pull the cylinder off your skin while a vacuum seal is active. Pulling a sealed tube can cause painful skin tears or severe bruising. Always press and hold the black pressure-release button to break the air seal completely before removing the pump.

3. Lubricant Compatibility (Critical for TPE & Silicone)

• Water-Based Only: You must strictly use a generous amount of high-quality water-based lubricant on your penis and the inner rim of the TPE/silicone comfort sleeve to ensure an airtight seal and a friction-free glide.

• Absolute Ban on Silicone and Oils: Never use silicone-based or oil-based lubricants (such as Vaseline, baby oil, or body lotions). The comfort sleeve components are made from TPE and silicone, which react aggressively to oil and synthetic fluids. Incorrect lubricants will permanently dissolve the TPE material, causing the sleeve to become permanently sticky, warped, weakened, and chemically unsafe for body contact.

4. Battery Installation & Motor Safety

• Correct Insertion: The automatic pump head requires 3 x AAA batteries (not included). Open the battery compartment on the top unit and insert the batteries, ensuring the positive (+) and negative (-) ends strictly match the internal polarity markings.

• Battery Maintenance: Never leave flat or dying batteries inside the pump head. Dead batteries leak toxic acid over time, which will instantly destroy the motorized circuitry and present a chemical burn hazard. Remove all 3 batteries completely if the pump will be left unused for more than a few weeks.

5. Water Restrictions & Electrical Hazards

• Non-Submersible Pump Head: While the ABS plastic cylinder and rubber sleeves are waterproof when detached, the motorized electronic pump head at the top is strictly non-waterproof and non-submersible.

• Avoid Water Submersion: Never use this automatic pump in the bath or under a running shower. If water enters the battery compartment or slips past the power buttons, it will permanently short-circuit the 3-speed motor, ruin the electronics, and potentially cause a mild electric shock.

6. Cleaning, Hygiene, and Porous Material Care

• Always Disassemble Before Washing: To clean the device safely, you must remove the electronic pump head from the top of the cylinder, and slide the flexible TPE/silicone comfort sleeve off the bottom base.

• Washing Protocol:

  • Cylinder & Sleeve: Wash the ABS tube and the flexible sleeves thoroughly with warm water and a mild, unscented antibacterial soap or a specialized adult toy cleaner.

  • Pump Head: Wipe the exterior of the plastic motorized head carefully with a damp antibacterial cloth; do not rinse it under a tap or submerge it.

• Porous Material Warning: TPE is a porous material that can trap bacteria, bodily fluids, and lint if not cleaned meticulously. Wash it immediately after every single use to prevent the buildup of pathogens.

• Strictly Do Not Boil: Never attempt to sterilize the TPE sleeve or ABS cylinder using boiling water, microwaves, or a dishwasher, as extreme heat will melt or warp the components permanently. Allow all parts to air-dry completely before reassembling.

7. Safe Storage

• Material Isolation (Critical): Never store the flexible TPE/silicone sleeve directly touching other adult toys in your collection. TPE contains plasticizers that interact aggressively with other materials; left in contact with silicone, PVC, or other TPE items, they will undergo a chemical reaction and permanently melt into a fused, sticky mess. Store your dried pump components completely isolated—ideally back in its box or wrapped inside a clean, separate, breathable cloth pouch. Keep it in a cool, dry place out of direct sunlight.

8. Regular Inspection

• Check for Cylinder Cracks: Before each use, inspect the clear ABS cylinder for any hairline cracks, deep scratches, or chips. Under heavy vacuum suction, a structurally compromised cylinder can violently crack or implode, causing severe lacerations to your skin.

• Check the Sleeves: Ensure the rubber sleeves are free from tears or splits that could cause vacuum leaks. Test the buttons to ensure the motor smoothly cycles through all 3 speeds and that the pressure-release button triggers instantly before applying the pump to your body.